Security alarm

Active filters

  • Categories: Radio clear
Receiver Gorke RSU-KO4 4-ch
Turime sandėlyje
type of receiving module: superreactionsensitivity: -100 dBmnumber of channels: 4memory capacity: 40 buttonsnominal voltage supply: 12 V DCallowable voltage supply: 10-15 V DCstatic power consumption: 22 mAmaximal power consumption: 104 mAcapacity:relay output: 1A/ 30 V DCrelay's operating mode: mono, bi, temporary or 2keytime scope for the mono mode: ~1s-4min15soperating temperature range: 0 to +40 °Cdimensions (mm): 48*68*26 
Remote control set GSN ACS-146R 4-ch
Out-of-Stock. Ask the seller
The wireless four-channel multifunctional receiver ACS-146R, operating in conjunction with two hand-held push-button transmitters, provides the remote control of any electronic equipment: Electrical gatesSliding doorsElectromagnetic locksAutomatic barriersElectrical curtainsLighting fixtures, etc.Can work with 12V
Stationary sender Gorke NRP-102 1-ch
Out-of-Stock. Ask the seller
GORKE NRP-102 is a stationary sender with range up to 1000m is used to forward the alarm signal from the monitored object. It has functions test signal is sent at 1h.Designed to work with receivers such as: OPC, IDO 04/99, IDO 500 and a monitoring station VIRGO 430The hermetic housing with IP67 protection allows for installation in unfavorable conditions humidity, low temperatures.BNC antenna socket allows disconnection and elevation of the antenna over obstacles.It has two independent input (normally closed) opening of either of them results in sending one or two (depending on the position of the armature) a transmission signal with a duration of 2 seconds with an interval of 1s.
Stationary sender Gorke NRP-102W 2-ch
Out-of-Stock. Ask the seller
GORKE NRP-102W is a stationary sender with range up to 1000m is used to forward the alarm signal from the monitored object. It has functions test signal is sent at 1h.Designed to work with receivers such as: OPC, IDO 04/99, IDO 500 and a monitoring station VIRGO 430The hermetic housing with IP67 protection allows for installation in unfavorable conditions humidity, low temperatures.BNC antenna socket allows disconnection and elevation of the antenna over obstacles.It has two independent input (normally closed) opening of either of them results in sending one or two (depending on the position of the armature) a transmission signal with a duration of 2 seconds with an interval of 1s.
Remote control Gorkel RNB - 101S
Out-of-Stock. Ask the seller
The remote control signals the low battery level. The battery’s life: about 20 000 typical transmissions (transmission length: 0,5s). The remote control cooperates with any type of receiver produced by GORKE. We advise to configure sets using the superheterodyne receivers. The range of such sets reaches up to 1000 metres. The configuration of RNB 101S with the superreactive receiver (RSU) results in 50% shorter range (because of the lower sensitivity of the receiver). The set consists of the remote control, antenna and a case with a belt hook. If there is a need, we can prepare a version with 2, 3, 4, 5, 6, 7 or 8 buttons.
Remote control Gorke RNB-101
Turime sandėlyje
The remote control signals the low battery level.The battery’s life: about 20 000 typical transmissions (transmission length: 0,5s).The remote control cooperates with any type of receiver produced by GORKE.We advise to configure sets using the superheterodyne receivers.The range of such sets reaches up to 1000 metres.The configuration of RNB 101 with the superreactive receiver results in 50% shorter range (because of the lower sensitivity of the receiver).The set consists of the remote control, antenna and a case with a belt hook.
Receiver Gorke OPC-KO1
Turime sandėlyje
The receiver cooperates with any sender of GORKE productionThe range of the sets comprising this receiver varies from 200 to 1000 metres (depending on the remote control
Receiver Gorke OPC-KO2
Turime sandėlyje
The receiver cooperates with any sender of our productionThe range of the sets comprising this receiver varies from 200 to 1000 metres (depending on the remote control
Transmitter T10
Turime sandėlyje
T10 is a data transmitting device for transmitting information of intruder and fire alarm control panel to monitoring and alarm receiving centre (MARC) at a licensed VHF radio frequencyTransmits information by VHF radio frequencyCan transmit by two radio frequencies in parallelMultiprotocol encodingTransmits information of Paradox, DSC, Caddx or Pyronix control panel's data busTransferred information corresponds to codes of Contact ID2 external inputsPower supply controlSetting of configuration via USB
Disabled WC Call System NC951
Turime sandėlyje
The UK's market-leading Disabled Persons Toilet Alarm kit.Includes everything required for a BS8300 clause compliant emergency assistance alarm.Attractively designed, easy to install and simple to use.Allows a distressed person to raise an alarm in the event of an emergency. To operate, the user pulls the cord of a ceiling pull to activate a light and sounder outside the WC and on the system's Call Controller.New ‘Call Accept’ functionality allows staff to send an intermittent call acknowledgment signal inside the WC to confirm help is on the way.Includes an NC943B 12V 140mA Call Controller c/w standby battery and relay, NC807C Ceiling Pull, NC806CS Overdoor Light c/w Sounder, NC809DBBT Accessible Toilet Reset Point c/w Sounder and NC949 Accessible WC Sticker.Can be wired in 4 core stranded security cable.Can also be used as a single zone emergency assistance alarm in changing rooms, solariums, interview rooms, reception areas and more.