Addressable systems

Manufacturer: ApolloHazard button coverPlasticTransparent

The Transparent Hinged Cover is for use with XP95 and Discovery Manual Call PointsCan be fitted to add further protection against accidental operation

Manufacturer: ApolloEmergency button key Plastic

It is designated to release a signal for a Fire condition to the Fire Control Panel IFS7002 upon manual activation by breaking the glass on the place, signed with arrows. The light indication for activating the manual call point is provided by a red LED. There is possibility for testing by a special key.It satisfies the requirements if the European Standard EN54-11 for a type A manual call point and EN54-17.

Easy access, front reset mechanismE-Z fit connector system for installationEN 54-11 & EN 54-17 Certified (Red version only)170° viewable LEDContinuity link for cable insulation testingSuitable for semi flush or surface mounting

Fire alarm buttonNO NC contacts

The Intelligent Input/Output Unit provides supervision of one or more normally open contacts connected to a single pair of cables and a set of changeover relay output contacts.

The Mini Switch Monitor is an interface within an entirely new housing. Designed in response to customer feedback, the smaller Mini Switch Monitor can be fitted onto a 35mm DIN-Rail with a twist-click motion or mounted in an enclosure such as a manual call pointIt is designed to monitor the state of one or more single pole, volt free contacts connected to a single pair of cables and to report the status to Apollo compatible control equipment

Improved design for ease of wiring meaning faster installation Contains controllable isolatorAddress range 1 - 254Nine pre-configured modes, including compatibility mode from XP95/Discovery to CoreProtocol systemsFailsafe mode (meets BS 7273-4 requirements)Configurable input stylesEarth fault monitoring

The Input/Output Unit provides a voltage-free, double pole changeover (DPCO) relay output, a single monitored switch input and an unmonitored, non-polarised opto-coupled input.

The Zone Monitor powers and controls the operation of a zone of up to 20 Apollo Series 65 or Orbis fire detectors from a Discovery or XP95 loop

The Output Unit provides a voltage free single pole, changeover relay output. It is a simplified version of the Input/Output Unit without circuitry for monitoring inputs.Capable of switching up to 30V at 1AVoltage free, change-over relay outputShort-circuit isolatorCapable of switching up to 30V at 1AWall mounted (surface)Dimensions: 150x90x48mm

The Three Channel Input/Output Unit provides three voltage-free, single pole, changeover relay outputs and three monitored switch inputs

Suitable for weatherproof applicationsEN 54-11 & EN 54-17 CertifiedResettable operating element170° viewable LEDXP95 & Discovery compatible

This manual fire alarm call point has been designed for use in flammable atmospheres and harsh environmental conditions. The GRP enclosure is suitable for use offshore or onshore where light weight combined with a high level of corrosion resistance is requiredZone 0, Zone 1 and Zone 2 useExed, Exia or weatherproofATEX approvedBASEEFA certifiedIP66 and IP67Certified temperature: –40°C to +50°C (Model dependent)Corrosion resistant red painted GRPRetained stainless steel cover screwsOptional lift flapKey operated test facilityLightweight and robustBreakglass hammer available (Contact sales office for details)