chevron_left
chevron_right
TELTONIKA industrial router LTE RUTX14
- 4G LTE CAT12
- 5 x Gigabit Ethernet ports
- Wave-2 802.11ac WIFI and „Bluetooth“ LE
- Aluminum housing
- GNSS
|
|
DPD Pick up terminal. Delivery within 1-8 days. ( from 3,00 €) |
|
|
Delivery via DPD courier service. Delivery within 1-8 days. ( from 4,00 €) |
- Mobile
- Mobile module4G (LTE) – Cat 12 up to 600 Mbps, 3G – up to 42 Mbps
- SIM/mobile module switch2 SIM cards, auto switch cases: weak signal, data limit, SMS limit, roaming, no network, network denied, data connection fail
- StatusSignal strength, SINR, RSRP, RSRQ, Bytes sent/received, connected band, carrier aggregation, IMSI, ICCID,
- SMSSMS status, SMS configuration, send/read SMS via HTTP POST/GET, Email to SMS, SMS to Email, SMS to HTTP, SMS to SMS, SMS auto replay
- Black/White list (planned)Operator black/white list
- Multiple PDNPossibility to use different PDNs for multiple network access and services
- Band managementBand lock, Used band status display
- APNAuto APN
- Bridge modeDirect connection (bridge) between mobile ISP and device on LAN
- Wireless
- Wireless mode802.11b/g/n/ac Wave 2 (WiFi 5) with data transmission rates up to 867 Mbps (Dual Band, MU-MIMO), 802.11r fast transition, Access Point (AP), Station (STA)
- WiFi securityWPA3-EAP, WPA3-SAE, WPA2-Enterprise-PEAP, WPA2-PSK, WEP; AES-CCMP, TKIP, Auto Cipher modes, client separation
- ESSIDESSID stealth mode
- WiFi usersup to 150 simultaneous connections
- Wireless HotspotCaptive portal (Hotspot), internal/external Radius server, built in customizable landing page
- Ethernet
- WAN1 x WAN port (can be configured as LAN) 10/100/1000 Mbps, compliance with IEEE 802.3, IEEE 802.3u, 802.3az standards, supports auto MDI/MDIX crossover
- LAN4 x LAN ports, 10/100/1000 Mbps, compliance with IEEE 802.3, IEEE 802.3u, 802.3az standards, supports auto MDI/MDIX
- Bluetooth
- Bluetooth 4.0Bluetooth low energy (LE) for short range communication
- Network
- RoutingStatic routing, Dynamic routing (BGP, OSPF v2, RIP v1/v2, EIGRP, NHRP)
- Network protocolsTCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSL v3, TLS, ARP, VRRP, PPP, PPPoE, UPNP, SSH, DHCP, Telnet client, SNMP, MQTT, Wake on LAN (WOL), DLNA
- VoIP passthrough supportH.323 and SIP-alg protocol NAT helpers, allowing proper routing of VoIP packets
- Connection monitoringPing Reboot, Wget reboot, Periodic Reboot, LCP and ICMP for link inspection
- FirewallPort forwards, traffic rules, custom rules
- DHCPStatic and dynamic IP allocation, DHCP Relay, Relayd
- QoS / Smart Queue Management (SQM)Traffic priority queuing by source/destination, service, protocol or port, WMM, 802.11e
- DDNSSupported >25 service providers, others can be configured manually
- Network backupVRRP, Mobile, Wired and WiFi WAN options, each of which can be used as an automatic Failover
- Load balancingBalance Internet traffic over multiple WAN connections
- SSHFSPossibility to mount remote file system via SSH protocol
- Security
- AuthenticationPre-shared key, digital certificates, X.509 certificates
- FirewallPre-configured firewall rules can be enabled via WebUI, unlimited firewall configuration via CLI; DMZ; NAT; NAT-T
- Attack preventionDDOS prevention (SYN flood protection, SSH attack prevention, HTTP/HTTPS attack prevention), port scan prevention (SYN-FIN, SYN-RST, X-mas, NULL flags, FIN scan attacks)
- VLANPort and tag based VLAN separation
- Mobile quota controlCustom data limits for both SIM cards
- WEB filterBlacklist for blocking out unwanted websites, Whitelist for specifying allowed sites only
- Access controlFlexible access control of TCP, UDP, ICMP packets, MAC address filter
- VPN
- OpenVPNMultiple clients and a server can run simultaneously, 12 encryption methods
- OpenVPN EncryptionDES-CBC, RC2-CBC, DES-EDE-CBC, DES-EDE3-CBC, DESX-CBC, BF-CBC, RC2-40-CBC, CAST5-CBC, RC2-64-CBC, AES-128-CBC, AES-192-CBC, AES-256-CBC
- IPsecIKEv1, IKEv2, with 5 encryption methods for IPsec (DES, 3DES, AES128, AES192, AES256)
- GREGRE tunnel
- PPTP, L2TPClient/Server instances can run simultaneously, L2TPv3 support
- StunnelProxy designed to add TLS encryption functionality to existing clients and servers without any changes in the program’s code
- DMVPNMethod of building scalable IPsec VPNs
- SSTPSSTP client instance support
- ZeroTierZeroTier VPN client support
- WireGuardWireGuard VPN client and server support
- System Characteristics
- CPUQuad-core ARM Cortex A7, 717 MHz
- RAM256 MB, DDR3
- FLASH storage256 MB, SPI Flash
- Firmware / Configuration
- WEB UIUpdate FW from file, check FW on server, configuration profiles, configuration backup
- FOTAUpdate FW/configuration from server
- RMSUpdate FW/configuration for multiple devices at once
- Keep settingsUpdate FW without losing current configuration
- Firmware customization
- Operating systemRutOS (OpenWrt based Linux OS)
- Supported languagesBusybox shell, Lua, C, C++
- Development toolsSDK package with build environment provided
- USB
- Data rateUSB 2.0
- ApplicationsSamba share, USB-to-serial
- External devicesPossibility to connect external HDD, flash drive, additional modem, printer
- Storage formatsFAT, FAT32, NTFS
- Input/Output
- Input1 x Digital Input, 0 - 6 V detected as logic low, 8 - 30 V detected as logic high
- Output1 x Digital Output, Open collector output, max output 30 V, 300 mA
- EventsSMS, Email, RMS
- I/O jugglerAllows to set certain I/O conditions to initiate event
- Power
- Connector4 pin industrial DC power socket
- Input voltage range9 – 50 VDC, reverse polarity protection, voltage surge/transient protection
- PoE (passive)Passive PoE. Possibility to power up through LAN1 port, not compatible with IEEE802.3af, 802.3at and 802.3bt standards
- Power consumptionIdle: <4 W, Max: <22 W
- Physical Interferences(PORTS, LEDS, ANTENNAS, BUTTONS, SIM)
- Ethernet5 x RJ45 ports, 10/100/1000 Mbps
- I/Os1 x Digital Input, 1 x Digital Output on 4 pin power connector
- Status LEDs2 x connection status LEDs, 3 x connection strength LEDs, 10 x Ethernet port status LEDs, 4 x WAN status LEDs, 1x Power LED, 2 x 2.4G and 5G WiFi LEDs
- SIM2 x SIM slots (Mini SIM - 2FF), 1.8 V/3 V, external SIM holders
- Power1 x 4 pin DC connector
- Antennas4 x SMA for LTE, 2 x RP-SMA for WiFi, 1 x RP-SMA for Bluetooth, 1 x SMA for GNNS
- USB1 x USB A port for external devices
- ResetReboot/User default reset/Factory reset button
- Other1 x Grounding screw
- Physical Specification
- Casing materialFull aluminium housing
- Dimensions (W x H x D)132 x 44 x 95 mm
- Weight515 g
- Mounting optionsDIN rail (can be mounted on two sides), flat surface placement
- Operating Environment
- Operating temperature-40 C to 75 C
- Operating humidity10 % to 90 % non-condensing
LTERUTX14
16 other products in the same category:
