Fire detectors

Active filters

Apollo S65 Flame Detector (55000-025APO)
Turime sandėlyje
Detector Apollo Flame S65 55000-025APO Voltage range: 6-33 V DC Holding voltage: 6 V min Alarm reset time: 1 second Angle of View (FOV): 90 degree cone IP protection class: IP66 Detector and base: 100 mm x 48 mm Operating temperature: -40 °C – +80 °C
€1,226.14
Apollo Series S65 Base
Turime sandėlyje
The bases have been designed to enable detectors to be plugged in without any need for force - particularly useful when fitting to suspended ceilings. All Series 65 bases are lockableThe standard base is identical to the Series 60 base, so uses the same part number, 45681-200. It contains no electronic parts which could be damaged during installation
Orbis LX Base
Turime sandėlyje
LX Base has two slots for fixing screws at a spacing of 51mm and 69mmOne way fitDetector locking mechanism
Orbis Marine TimeSaver Base
Out-of-Stock. Ask the seller
The Orbis Marine TimeSaver Base is a completely new design that provides installers with an open working area with fixing holes shaped to allow a simple mounting procedureGrouped terminals to make wiring easyMultiple fixing centresLED alignment markCable stripping guideContinuity link for voltage testing of zone wiring prior to commissioningDetector locking mechanism
Orbis Heat Detectors
Turime sandėlyje
The Orbis Heat Detector monitors the temperatureRed flashing LED at StartUp confirms that the device is operatingSensAlert, yellow flashing LED, indicates faulty operation
Orbis Heat Detector
Turime sandėlyje
Heat Detector monitors the temperature by using a single thermistor which provides a coltage output proportional to the external air temperature
Orbis Optical Smoke Detector
Turime sandėlyje
Optical Smoke Detector operates on the well established light scatter principle. The sensing technology used to radically different from the previous optical detectors and significantly reduces false alarms
Orbis TimeSaver Relay Base
Turime sandėlyje
The TimeSaver Relay Base incorporates a single-pole, voltage-free, changeover contact for switching external equipment. When the detector changes to the alarm state, the relay is energised, causing the contact to change state. The contact will remain in this condition until the detector is resetGrouped terminals to make wiring easyTwo fixing centresLED alignment markCable stripping guideDetector locking mechanismContinuity link for voltage testing of zone wiring prior to commissioningCapable of switching up to 30V at 1A
ORBIS IS heat detector
Turime sandėlyje
The Orbis IS range incorporates seven heat detector classes to suit a wide variety of operating conditions in which smoke detectors are unsuitable. The European standard EN54-5:2000 classifies heat detectors according to the highest ambient temperature in which they can safely be used without risk of false alarm.